KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
- 10. A suspension bracket
   10.1. Specifications
   10.2. Check of elements of a forward suspension bracket
   10.3. Check and adjustment of corners of installation of wheels
   10.4. A convergence of forward wheels
   10.5. A rack of a forward suspension bracket
   10.6. The bottom lever of a forward suspension bracket
   10.7. The forward stabilizer of cross-section stability
   10.8. A beam of a back suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


зайти и посмотреть Top valuation companies




10.3. Check and adjustment of corners of installation of wheels

Preliminary check

PERFORMANCE ORDER
1. Check up pressure in tyres and, if necessary, finish to the demanded.
2. Check up люфт bearings of forward wheels and, if necessary, replace.
3. Check up palpation of tyres and wheels.
4. Check up absence люфта spherical hinges of a forward suspension bracket
5. The car should be on a flat horizontal surface without passengers and cargo in a luggage carrier.
6. Distinction in height between the left and right party of the car from the centre of a wheel to wing edge should not exceed 10 mm.

The prevention

Disorder and corner rotary шкворня are not regulated.


7. Check up that a fuel tank full, levels of a cooling liquid and engine oil both the spare wheel and tools are in norm on the places.

Check of the maximum angle of rotation of forward wheels

PERFORMANCE ORDER
1. Establish both lobbies of a wheel in a template of radius of turn.
2. Turn forward wheels to the left against the stop and measure an angle of rotation left (internal) and right (external) wheels.
3. Loosen the the left and right counternuts of tips of steering draughts, then, rotating draughts, establish demanded corners. Tighten counternuts.
4. Repeat these operations after turn of forward wheels to the right against the stop.
5. Tighten counternuts of tips of steering draughts.

The inhaling moment: 34–50 Nm

6. Check up and, if necessary, adjust a convergence after check and adjustment of the maximum angle of rotation of forward wheels.