KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
- 10. A suspension bracket
   10.1. Specifications
   10.2. Check of elements of a forward suspension bracket
   10.3. Check and adjustment of corners of installation of wheels
   10.4. A convergence of forward wheels
   10.5. A rack of a forward suspension bracket
   10.6. The bottom lever of a forward suspension bracket
   10.7. The forward stabilizer of cross-section stability
   10.8. A beam of a back suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


Фены, все новости дня




10.4. A convergence of forward wheels Check

PERFORMANCE ORDER
1. Lift a forward part of the car so that forward wheels have slightly risen over the earth.
2. Manually turn wheels and spend lines on the centre of tyres.
3. Establish forward wheels for movement directly forward and lower the car.
4. Measure distance between the spent lines from the forward and back parties of wheels. Both distances should be measured on identical distance from the earth. The distance between wheels in a back part should be more than in a forward part on 43 mm.

Adjustment

If the convergence does not correspond to demanded value, ослабьте the left and right counternuts of tips of steering draughts, then rotating draughts establish demanded corners. Tighten counternuts.


The prevention

The left and right tips of steering draughts have the right carving. For reduction the convergence is necessary to rotate the right and left steering draughts, turning out them from tips of steering draughts and on the contrary.

One full turn of both connecting draughts changes a positive convergence approximately to 6 mm. Can be it is necessary to rotate one steering draught more than another to reach a demanded corner of a convergence, at preservation of installation of position of a steering wheel.


PERFORMANCE ORDER
Tighten counternuts of tips of steering draughts.

The inhaling moment: 34–50 Nm