KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
- 10. A suspension bracket
   10.1. Specifications
   10.2. Check of elements of a forward suspension bracket
   10.3. Check and adjustment of corners of installation of wheels
   10.4. A convergence of forward wheels
   10.5. A rack of a forward suspension bracket
   10.6. The bottom lever of a forward suspension bracket
   10.7. The forward stabilizer of cross-section stability
   10.8. A beam of a back suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


Ванная комната, более подробно тут.




10.7. The forward stabilizer of cross-section stability
THE GENERAL DATA

The forward stabilizer of cross-section stability

1 – draught of the stabilizer;
2 – a nut;
3 – a nut;
4 – the rubber plug of the stabilizer;
5 – a stabilizer arm;
6 – an assembly bolt;
7 – a bolt;
8 – the stabilizer of cross-section stability.

Removal

PERFORMANCE ORDER
1. Adaptation OK201 170 AA0 support the engine.
2. Lift a forward part of the car and fix on support.
3. Remove a wheel.
4. Disconnect draught of the stabilizer from the stabilizer of cross-section stability.
5. Turn away a nut and disconnect draught of the stabilizer of cross-section stability from a rack of a forward suspension bracket.
6. Remove arms of fastening of the stabilizer of cross-section stability.
7. Turn out bolts of fastening of a forward part of a plate of protection of the engine.
8. Lower a forward part of a plate of protection of the engine so that it was possible to take the stabilizer.
9. Remove the stabilizer of cross-section stability.

Check

Check up following places and restore or, if necessary, replace details:

      – Deterioration or damage of rubber plugs;
      – Presence of deformation or stabilizer cracks.

Installation
PERFORMANCE ORDER
1. Establish the stabilizer plug according to the adjusting labels put on the stabilizer.
2. Establish the stabilizer behind a plate of protection of the engine.

3. Lift a forward part of a plate of protection of the engine and fix its bolts and nuts.

The inhaling moment:
Bolts: 65–90 Nm
Nuts: 39–52 Nm

4. Establish arms of fastening of the stabilizer and fix bolts, having tightened their demanded moment.

The inhaling moment: 36–56 Nm

5. Establish draughts of the stabilizer on arms and fix their nuts.

The inhaling moment: 43–60 Nm

6. Establish draughts of the stabilizer on the stabilizer and fix their nuts.

The inhaling moment: 43–60 Nm


The prevention

Tighten nuts of fastening of draughts of the stabilizer the demanded moment after car installation on wheels (under loading).


7. Establish a wheel.
8. Lower the car.
9. Remove adaptation OK201 170 AA0A supporting the engine.