KIA RIO

Since 2000 of release

Repair and car operation

If tyre replacement by an aluminium wheel disk and use of steel tools, for an exception of damage of a disk is spent, between a disk and the tool lay a rubber protective insert.
Work carry out on a rubber mat, instead of on a firm surface.

Installation and repair of tyres demands the special tool and professional skills. Professionals should carry out these works only.


Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
- 11. Wheels and tyres
   11.1. Specifications
   11.2. Recommendations about replacement of tyres
   11.3. Check of pressure of air and a condition of tyres
   11.4. Palpation of wheels
   11.5. Shift of wheels
   11.6. Balancing of wheels
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


Get information of carder forums prvtzone take a look here however




11.2. Recommendations about replacement of tyres
THE GENERAL DATA

Pay attention to following recommendations about removal and installation of tyres on wheel disks.

Be careful, that at installation not to damage an internal lateral surface of a rim of a wheel or external edge of an internal lateral surface of a seat of the tyre.

Wire brush or emery paper clear all rust and-or a dirt from an internal lateral surface of a rim of a wheel.

Clearing of aluminium wheel disks spend with use only a soft fabric.

Remove from a tyre protector all extraneous subjects, such as a pebble, glass splinters, nails etc.

Check up correctness of installation of the gate.

For tightness check use a soap solution.