KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. A brake pedal
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







13.12. Repair of the working brake cylinder
THE GENERAL DATA

The working brake cylinder

1 – a dustproof cap;
2 – the prorolling union;
3 – a dustproof cover;
4 – the piston;
5 – a sealing ring;
6 – a sealing ring of the piston;
7 – the case of the working brake cylinder;
8 – a spring;
9 – a sealing ring of the piston;
10 – the piston;
11 – a dustproof cover.

Dismantling

PERFORMANCE ORDER
1. Remove dustproof covers from two parties of the working brake cylinder.
2. Pushing through the case of the working brake cylinder remove pistons and a spring.
3. Remove from pistons sealing rings.
4. Remove a dustproof cap, turn out the union of prorolling and take a steel ball.

The prevention

Do not use oil, solvent, kerosene or gasoline for clearing of details of the working brake cylinder. At their use as clearing means, their rests can remain on details and further to damage rubber consolidations.


5. Wash out support details in pure denatured alcohol and drain their stream of compressed air.

Assemblage

PERFORMANCE ORDER
1. Establish on pistons sealing rings.
2. Grease all internal details with a pure brake liquid.
3. Establish a spring, pistons and dustproof covers.
4. Establish a steel ball, screw the union of prorolling and establish a dustproof cap.