KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. A brake pedal
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







13.14. The pressure terminator
THE GENERAL DATA

The pressure terminator

1 – a brake tube from the main brake cylinder;
2 – a brake tube to the forward right working brake cylinder;
3 – a brake tube to the forward left working brake cylinder;
4 – the pressure terminator;
5 – a brake tube to the back left working brake cylinder;
6 – a brake tube to the back right working brake cylinder.

Removal

PERFORMANCE ORDER
1. Remove a brake pipe.
2. Turn out a bolt.
3. Remove the pressure terminator.

Installation

Installation of the terminator of pressure is spent to sequences, return to removal.

After installation add a brake liquid and remove air from a hydraulic contour of brake system.

Check of the terminator of pressure

PERFORMANCE ORDER

1. Connect adaptation OKK30 140 001 to brake tubes, as is shown in drawing.

The moment of an inhaling of the adaptation and connecting nuts: 12,8–21,5 Nm

2. Remove air from a hydraulic contour of brake system.
3. Press a brake pedal while forward pressure will not be equal in brake system And and write down back pressure in brake system And.
4. Again press a pedal of a brake with additional effort while pressure will not be equal in brake system In and write down pressure in brake system of Century

Pressure of a liquid

Forward pressure in brake system, кПа
Back pressure in brake system, кПа
AND
2942
AND
2942
IN
5394
IN
3677

The prevention

Do not try to regulate the pressure terminator.

After check remove air from a hydraulic contour of brake system and check up absence of leaks of a brake liquid.

If the measured values do not correspond demanded, replace the pressure terminator.