KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. A brake pedal
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


Туризм и страхование: договор на туристическое страхование путешественников




13.17. The block of hydraulic management (HCU)
THE GENERAL DATA

The block of hydraulic management (HCU)

1 – the block of hydraulic management (HCU);

2 – arm HCU;

3 – a brake tube;

4 – a socket

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Having pulled, release a clamp and disconnect a socket from the block of hydraulic management.
3. A nakidnym wrench disconnect brake tubes. Collect the leaked brake liquid.
Temporarily close the ends of tubes plastic stoppers for a hit exception in them of pollution.
4. A nakidnym wrench turn out bolts and nuts of fastening of an arm of the block of hydraulic management and remove an arm.
5. Temporarily close apertures in the block plastic stoppers for a hit exception in them of pollution.
6. Store the block of hydraulic management in the protective container.

Installation

PERFORMANCE ORDER
1. Establish an arm of the block of hydraulic management on the car and fix bolts and nuts.
2. Repeatedly connect tubes of brake system.
3. Connect a socket to the block of hydraulic management.
4. Remove air from a hydraulic contour of brake system.