KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. A brake pedal
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment


матчи в записи, здесь




13.19. The back gauge of frequency of rotation of a wheel

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Turn out a bolt of fastening of the back shock-absorber.
3. Remove the gauge from a brake board.
4. Release a clip of fastening of a wire of the gauge.
5. After removal of back sitting and back lateral furnish of a door, remove gauge ABS and its socket.

Installation

PERFORMANCE ORDER
1. Establish gauge ABS and its socket.
2. Establish a back seat and back lateral furnish of a door.
3. A clip fix a gauge wire.
4. Establish gauge ABS in a brake board.

The inhaling moment: 8–12 Nm

5. Screw the bottom bolt of fastening of the back shock-absorber.

The inhaling moment: 78–98 Nm

6. Connect a wire to the negative plug of the storage battery.