Since 2000 of release

Repair and car operation

Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   + 13.8. A brake pedal
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment

13.3. The unilateral vacuum valve

The prevention

The unilateral vacuum valve is established in a vacuum hose. The arrow on a hose specifies a direction of installation of a hose (to the vacuum amplifier).

1. Loosen the collars also remove a vacuum hose with the unilateral vacuum valve.
2. Create depression from the hose end face, fastening to the engine. Air should pass. If air passes on a hose in both directions or at all does not pass, the valve is faulty also a hose it is necessary to replace.