KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   - 13.8. A brake pedal
      13.8.1. Height of installation of a pedal of a brake
      13.8.2. A free wheeling of a pedal of a brake
      13.8.3. Distance of a pedal of a brake from a floor
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







13.8. A brake pedal
THE GENERAL DATA

Brake pedal

1 – a lock washer;
2 – a nut;
3 – a bolt;
4 – the plug;
5 – распорная the plug;
6 – a pin with a head and an aperture under шплинт;
7 – a returnable spring;
8 – шплинт;
9 – a rubber emphasis;
10 – a brake pedal.

Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. In car salon take шплинт, крепящий a pin with a head and an aperture under шплинт and take a pin.
3. Turn away a nut and remove a lock washer.
4. Remove распорную the plug with шарнирного a bolt.
5. Move a bolt to the right and remove it.
6. Remove a brake pedal, a returnable spring and распорные plugs.
7. If necessary remove an overlay of a pedal of a brake and a rubber emphasis.

Installation

PERFORMANCE ORDER
1. If necessary establish a rubber emphasis of a pedal of a brake, a pedal of a brake and the plug of a pedal of a brake.
2. Establish распорную the plug of a pedal of a brake and шарнирный a bolt.
3. Establish a returnable spring of a pedal of a brake.
4. Establish a coupling pedal.
5. Establish распорную the plug of a pedal of coupling.
6. Establish шарнирный a bolt, a washer and screw a nut.
7. Establish a pin with a head and an aperture under шплинт and new шплинт.
8. Connect a wire to the negative plug of the storage battery.
9. After installation check up and adjust height of installation of a pedal and a free wheeling of a pedal of a brake.