KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Check of the vacuum amplifier of brakes with use of devices
   13.3. The unilateral vacuum valve
   13.4. The vacuum amplifier of brakes
   13.5. Prorolling of hydraulic system of a drive of brakes
   13.6. Check of brake tubes
   13.7. Check and replacement of brake hoses
   - 13.8. A brake pedal
      13.8.1. Height of installation of a pedal of a brake
      13.8.2. A free wheeling of a pedal of a brake
      13.8.3. Distance of a pedal of a brake from a floor
   13.9. Replacement of lobbies brake колодок
   13.10. Replacement brake колодок on back drum-type brakes
   13.11. Repair of a support of a forward brake
   13.12. Repair of the working brake cylinder
   13.13. The main brake cylinder
   13.14. The pressure terminator
   13.15. A lay brake
   13.16. The block of management ABS
   13.17. The block of hydraulic management (HCU)
   13.18. The forward gauge of frequency of rotation of a wheel
   13.19. The back gauge of frequency of rotation of a wheel
   + 13.20. A gear rotor of the gauge of frequency of rotation of a wheel
   13.21. The basic survey
   13.22. Check of functionality
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







13.8.1. Height of installation of a pedal of a brake

Check


Measure distance from the centre of a pedal of a brake to a carpet covering of a floor.

Distance: 170176 mm

Adjustment

PERFORMANCE ORDER
1. Disconnect a socket from the switch of stop signals.
2. Loosen the counternut B also rotate the switch while it does not contact with a pedal.
3. Loosen the counternut D and, rotating pusher C, adjust height of installation of a pedal of a brake. If necessary turn out the switch to interfere with its contact to a brake pedal.
4. Screw the switch so that it плунжер has been completely drowned in the switch case, then turn out the switch on S a turn. Tighten counternuts B and D.

The inhaling moment: 23,534,3 Nm

5. Connect a socket to the switch of stop signals and check up action of stop signals.