KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
- 14. A body
   14.1. The inhaling moments
   14.2. A cowl
   14.3. A luggage carrier cover
   14.4. The hinge of a cover of a luggage carrier
   14.5. A luggage space door
   14.6. A gazonapolnennaja rack of support of a door of a luggage space
   14.7. The lock of a door of a luggage space
   14.8. The external handle of a door of a luggage space
   14.9. A forward door
   14.10. Vlagozashchitnoe consolidation of a door
   14.11. A back door
   14.12. The panel of devices
   14.13. A ceiling
   14.14. A lateral upholstery of a luggage carrier of five-door cars
   14.15. A back upholstery of a luggage carrier
   14.16. The top upholstery of a forward rack
   14.17. The bottom upholstery of the central rack
   14.18. The top upholstery of the central rack
   14.19. An upholstery of a back rack of four-door cars
   14.20. An upholstery of a back rack of five-door cars
   14.21. An upholstery of a forward door
   14.22. An overlay of a threshold of a forward door
   14.23. An upholstery of a back door
   14.24. An upholstery of a door of a luggage space
   14.25. An overlay of a threshold of a back door
   14.26. A back shelf
   14.27. An upholstery of an arch of a back wheel of four-door cars
   14.28. An upholstery of an arch of a back wheel of five-door cars
   14.29. A forward bumper
   14.30. A back bumper
   14.31. Forward seats
   14.32. An upholstery of a back of a forward seat
   14.33. An upholstery of a pillow of a forward seat
   14.34. A headrest
   14.35. The leaning back hinge of a forward seat
   14.36. Back sitting
   14.37. Seat belts
   14.38. Seat belts of a back seat
   14.39. Скоба fastenings of a back seat belt
   14.40. The distances designed on a plane, for check of distances between separate points of a body of the car
   14.41. Actual distances of check of distances between separate points of a body of the car
+ 15. Air central air
+ 16. The electric equipment


вэбкамеры чат crazyroyal




14.37. Seat belts
THE GENERAL DATA

Seat belts

1 – a forward clamp of fastening of a belt;
2 – a humeral belt of a forward seat;
3 – натяжитель a seat belt;
4 – a uvula of the central seat belt of a back seat;
5 – a clamp of fastening of a seat belt of a back seat.

The system of seat belts consists of five belts. Seat belts of the driver and lateral passengers have three-dot fastening. Zone seat belts of back passengers have point-to-point fastening.

Seat belts of the driver are equipped by the alarm system which warns the driver ignition of a control lamp in a combination of devices and a sound signal. The prevention automatically stops approximately through 60 with. Seat belts of passengers are not equipped by the alarm system.

Натяжители seat belts are fixed on a body.

Removal


The prevention

The mechanism of a preliminary tension works only once then it is necessary to replace it.

Do not try to remove or repair the mechanism of a preliminary tension of a seat belt. If the mechanism works with failures, replace it.

Exclude hit of water or oil in the mechanism of a preliminary tension of a seat belt. Otherwise replace the mechanism.

Connect a wire to the negative plug of the storage battery only after correct installation of the mechanism of a preliminary tension of a seat belt.

Removal preliminary натяжителя a seat belt spend in a following order:

      – Switch off ignition;
      – Disconnect a wire from the negative plug of the storage battery;
      – Wait approximately for 1 mines;
      – Disconnect a socket gas generator;
      – Turn out the fastening screw натяжителя a seat belt.


PERFORMANCE ORDER
1. Turn out one bolt from the top arm and remove an arm.
2. Slowly release a belt before its retraction inertial натяжителем a seat belt as far as possible.
3. Having pulled uncover, closing анкерный a bolt of the top fastening of a seat belt.
4. Turn out one анкерный a bolt.
5. Remove the bottom panel of furnish of the central rack.
6. Turn out one bolt and one screw and remove inertial натяжитель a seat belt.

Check

PERFORMANCE ORDER
1. Check up a condition of a clamp of fastening of a seat belt.
2. Check up a condition скобы the top fastening of a seat belt.
3. Remove the bottom panel of furnish of the central rack.
4. Visually check up a condition натяжителя a seat belt.
5. Establish the bottom panel of furnish of the central rack.
6. Extend a seat belt and check up smoothness of its course.
7. If at вытягивании there is a belt jamming, replace it.
8. Check up reliability of fastening of a belt a clamp.
9. Press the button of a clamp and be convinced that the uvula easily leaves a clamp.
10. Check up system of the precautionary alarm system which warns the driver ignition of a control lamp in a combination of devices and a sound signal.

Installation

PERFORMANCE ORDER

1. Establish inertial натяжитель a seat belt and fix its one bolt and the screw.

The inhaling moment: 40–55 Nm


The prevention

At installation натяжителя a seat belt do not overwind a belt and exclude formation of loops. Incorrectly established belt is not capable to protect the passenger at accident. The overwound belt changes distribution of forces arising at sudden delay of the car.


2. Establish directing a belt.
3. Establish the top panel of furnish of the central rack.
4. Establish the bottom panel of furnish of the central rack.

5. Screw анкерный a bolt.

The inhaling moment: 40–55 Nm

6. Establish a cover анкерного a bolt.

7. Screw one bolt of fastening of an arm of a seat belt.

The inhaling moment: 40–55 Nm