KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. Air central air
   15.1. Specifications
   15.2. A contour of a central air of air
   15.3. Remarks at replacement of elements of a central air of air
   15.4. Connection of elements of a central air of air
   15.5. Safety measures
   15.6. Check of operational characteristics
   15.7. Diagnostics a central air of air with use of manometres
   15.8. Check of a backlash of coupling of the compressor of the conditioner
   15.9. Check of coupling of the compressor of the conditioner
   15.10. Oil for greasing of the compressor of the conditioner
   15.11. Check of level and доливка oils in the conditioner compressor
   15.12. The air filter of the evaporator
   15.13. The gauge of double pressure
   15.14. The conditioner compressor
   15.15. Condenser check
   15.16. Check of the fan of the condenser
   15.17. Check of the receiver \of a dryer
   15.18. Check of the thermostatic gauge (термистора)
   15.19. Check of the engine of the fan
   15.20. Check of the block of resistors of the engine of the fan
   15.21. The switch of giving of air in car salon
   15.22. The control panel air central air
+ 16. The electric equipment







15.14. The conditioner compressor

Removal and installation

PERFORMANCE ORDER
1. On cars without the steering amplifier ослабьте bolt A of fastening of the mechanism of a tension, ослабьте an adjusting bolt In also remove a belt of a drive of the compressor of the conditioner.
2. On cars with the steering amplifier ослабьте bolts A, B and C, ослабьте adjusting bolt D also remove a belt of a drive of the compressor of the conditioner.
3. Discharge air central air.
4. Disconnect hoses from the conditioner compressor.
5. Remove the conditioner compressor. Immediately close all open apertures and tubes for an exception of hit of a moisture of air in air central air.
6. Installation of the compressor of the conditioner is spent to sequences, return to removal, taking into account the following:

      – Fill in in the compressor fresh oil;
      – Before installation of sealing rings, oil them;
      – Do not grease connecting nuts of unions of the compressor of the conditioner;
      – Tighten entrance and target hoses the demanded moment;
      – Adjust a tension of a belt of a drive of the compressor of the conditioner.

The inhaling moment: 24–36 Nm

7. Fill with a coolant air central air.