KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
- 16. The electric equipment
   16.1. Specifications
   16.2. Electric chains
   - 16.3. The generator
      16.3.1. Generator check
      16.3.2. A belt of a drive of the generator
      16.3.3. Removal, repair and generator installation
   + 16.4. The storage battery
   16.5. A starter
   16.6. Check at проворачивании a cranked shaft not the heated-up engine
   16.7. Check of an electric chain of the traction relay
   16.8. Check of the traction relay
   16.9. Check of brushes and щеткодержателя
   16.10. Check of coils статора
   16.11. Rotor check
   16.12. Removal and starter installation
   16.13. Starter repair
   16.14. The multipurpose switch
   16.15. A sound signal
   16.16. The block of safety locks and the relay, established in car salon
   16.17. Check of the relay of the activator of the lock of a door
   16.18. Check of the switch of adjustment of position of an external rear-view mirror
   16.19. Check of the activator of position of an external rear-view mirror
   16.20. Engine check стеклоподъемника
   16.21. Check of a heater of back glass
   16.22. Repair of a current-carrying strip of a heater
   16.23. The engine of a screen wiper of a windscreen
   16.24. Стеклоомыватели
   16.25. Adjustment of light of headlights
   16.26. Adjustment of light of antifog headlights
   16.27. Safety pillows (SRS)
   16.28. Precautionary labels
   16.29. A pillow of safety of the driver and a spiral wire
   16.30. Check of a pillow of safety
   16.31. Check of a spiral wire (spring)
   16.32. A pillow of safety of the forward passenger
   + 16.33. Electric schemes







16.3.1. Generator check
PERFORMANCE ORDER
1. Check up a condition of the storage battery.
2. Check up a condition of the wires connected to the storage battery, plugs of the storage battery, to the traction relay of a starter and the starter relay.
3. Check up integrity of fuses in the block of the relay / of safety locks in a motor compartment and the block of safety locks in car salon.
4. Check up reliability of an inhaling of bolts of fastening of the generator.
5. Check up a condition of a belt of a drive of the generator and its tension.
6. Check up reliability of connection of wires to the generator and connection with "weight" of the block of cylinders of the engine.

Check of resistance of elements of system of gymnastics

This check will show a power failure from a generator exit (plug B +) to the positive plug of the storage battery. Also the power failure from "mass" contact of the generator (–) to the negative plug of the storage battery will be defined.

PERFORMANCE ORDER
1. Tighten a lay brake, be convinced that the transmission is in neutral position (a mechanical transmission) or in parking position (an automatic transmission) and start up the engine.
2. Establish the fan switch on the maximum frequency of rotation.
3. Include a headlight of headlights and illumination in car salon.
4. Increase frequency of rotation of a cranked shaft to 2400 mines-1 and keep it at check carrying out.
5. Connect negative щуп the digital voltmeter to the positive plug of the storage battery.
6. The second щуп the digital voltmeter connect to the target plug of generator B +. The pressure shown by the voltmeter should be no more than 0,6 Century
7. If pressure above than 0,6 In, connect positive щуп the digital voltmeter to a nut of fastening of the target plug of the generator and contact of the electric socket connecting a chain between the generator and the storage battery.
8. If the pressure shown by the voltmeter became less than 0,6 In, means it is necessary to clean contacts of an electric socket or to provide reliable contact between them.
9. Connect negative щуп the voltmeter to the negative plug of the storage battery.
10. Connect positive щуп the voltmeter to "mass" contact of the generator (–).Напряжение, shown than 0,3 Century should be the voltmeter no more
11. If pressure above, than 0,3 In, connect positive щуп the voltmeter to a nut of fastening of a "mass" wire and contact of the electric socket connecting a chain.
12. If the pressure shown by the voltmeter became less than 0,3 In, means it is necessary to clean contacts of an electric socket or to provide reliable contact between them.