KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
- 16. The electric equipment
   16.1. Specifications
   16.2. Electric chains
   + 16.3. The generator
   + 16.4. The storage battery
   16.5. A starter
   16.6. Check at проворачивании a cranked shaft not the heated-up engine
   16.7. Check of an electric chain of the traction relay
   16.8. Check of the traction relay
   16.9. Check of brushes and щеткодержателя
   16.10. Check of coils статора
   16.11. Rotor check
   16.12. Removal and starter installation
   16.13. Starter repair
   16.14. The multipurpose switch
   16.15. A sound signal
   16.16. The block of safety locks and the relay, established in car salon
   16.17. Check of the relay of the activator of the lock of a door
   16.18. Check of the switch of adjustment of position of an external rear-view mirror
   16.19. Check of the activator of position of an external rear-view mirror
   16.20. Engine check стеклоподъемника
   16.21. Check of a heater of back glass
   16.22. Repair of a current-carrying strip of a heater
   16.23. The engine of a screen wiper of a windscreen
   16.24. Стеклоомыватели
   16.25. Adjustment of light of headlights
   16.26. Adjustment of light of antifog headlights
   16.27. Safety pillows (SRS)
   16.28. Precautionary labels
   16.29. A pillow of safety of the driver and a spiral wire
   16.30. Check of a pillow of safety
   16.31. Check of a spiral wire (spring)
   16.32. A pillow of safety of the forward passenger
   + 16.33. Electric schemes


заказать цветы, это и многое другое.




16.6. Check at проворачивании a cranked shaft not the heated-up engine
PERFORMANCE ORDER
1. Connect щупы the digital voltmeter to plugs of the storage battery.
2. Be convinced that the lay brake is completely tightened. On cars with an automatic transmission establish the selector lever in position PARK. On cars with a mechanical transmission establish the gear change lever in neutral position.
3. Be convinced that all consumers of electric energy are switched off.
4. Include ignition and a starter and observe of voltmeter indications.
5. If pressure more low 9,6 In, remove a starter and conduct bench tests. If bench tests have yielded negative result, replace a starter.
6. If pressure above 9,6 In, and a consumed current below demanded value, inspect on a power failure.
7. If the pressure shown by the voltmeter 12,5 In or more, and a starter does not work, check up working capacity of the traction relay.
8. If the pressure shown by the voltmeter 12,5 In or more and a starter turns a cranked shaft of the engine very slowly, inspect on a power failure.