KIA RIO

Since 2000 of release

Repair and car operation

Kia Rio
- 1.1. Short acquaintance to the car
   1.2. Keys
   1.3. Locks of doors
   1.4. An immobilizer
   1.5. Electric стеклоподъемники
   1.6. Seats
   1.7. Seat belts
   1.8. Back seat belts
   1.9. Safety pillows
   1.10. Components of system of pillows of safety
   1.11. A control lamp of a pillow of safety
   1.12. A luggage carrier door (5-door model)
   1.13. A luggage carrier cover
   1.14. A lamp of a luggage compartment
   1.15. A cowl
   1.16. Лючок a fuel tank
   1.17. A steering wheel
   1.18. Rear-view mirrors
   1.19. Salon illumination
   1.20. The salon equipment
   1.21. A digital watch
   1.22. Шторка a luggage carrier
   1.23. Power supplies socket
   1.24. The aerial
   1.25. The hatch in a roof
   1.26. The holder for sun glasses
   1.27. A cargo luggage grid
   1.28. The top luggage carrier
   1.29. The ignition switch
   1.30. Engine start-up
   1.31. A mechanical transmission
   1.32. An automatic transmission
   1.33. Brake system
   1.34. A lay brake
   1.35. The hydraulic amplifier of a steering
   1.36. An adjustable steering column
   1.37. A combination of devices
   1.38. Headlights
   1.39. Turn indexes
   1.40. The proof-reader of light of headlights
   1.41. Illumination of a day mode of operation
   1.42. Back antifog lanterns
   1.43. Screen wipers and стеклоомыватели
   1.44. A heater of back glass
   1.45. A heater of an external rear-view mirror
   1.46. Heating and ventilation system
   1.47. System work
   1.48. Information on tablets
   1.49. The emergency light alarm system
   1.50. Start-up of the engine from the storage battery of other car
   1.51. Safety locks
   1.52. Safety lock Memory
   1.53. Car towage
   1.54. Screen wiper brushes
   1.55. Replacement of lamps
   1.56. Care of appearance of the car
   1.57. Maintenance service
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment

На сайте http://www.raskrutkainstagram.com накрутка подписчиков в инстаграме бесплатно.

1.55. Replacement of lamps

THE GENERAL DATA

REPLACEMENT OF THE LAMP OF THE HEADLIGHT (FOUR-DOOR MODELS)

The prevention
At lamp replacement protect eyes. Wait, that the lamp has cooled down, but only then replace it.

Galogennye lamps are filled by gas under pressure. In a case разбития галогенная the lamp will blow up also its splinters will scatter every which way.

Always handle with care with галогенной a lamp and avoid рисок and scratches. If lamps burn, prevent their contact to liquids. Never concern glasses barehanded. The fat rests can cause an overheat and lead to lamp explosion if it burns. The lamp can be included only after its installation.

PERFORMANCE ORDER

1. Open a cowl.

2. Disconnect an electric socket from a lamp, having pressed a socket from two parties.

3. Release a wire spring of fastening of a lamp of a headlight, having pressed its end and having pulled upwards.

4. Take a lamp from three grooves on a headlight.

5. Establish a new lamp in three grooves on a headlight and latch a wire spring of fastening of a lamp in fixing position.

6. Connect an electric socket of a lamp of a headlight.

REPLACEMENT OF THE LAMP OF THE FORWARD INDEX OF TURN / OF LAY FIRES

PERFORMANCE ORDER

1. Turn a cartridge of a lamp of lay fires counter-clockwise take it from the headlight block.

2. Take a lamp from a cartridge, having pulled for it.

3. Establish a new lamp in a cartridge.

4. Establish a cartridge of a lamp of lay fires in the block of a headlight and turn it clockwise for cartridge blocking on a place.

REPLACEMENT OF THE LAMP OF THE BACK INDEX OF TURN

PERFORMANCE ORDER

1. By means of a crosswise screw-driver turn out screws of fastening of the back combined lantern to a body.

2. Cautiously remove knot of a lantern from the car.

3. Turn a lamp cartridge counter-clockwise and take it from the case.

4. Press a lamp and turn it on a turn quarter counter-clockwise then take a lamp from a cartridge.

5. Insert a new lamp into a cartridge then press a lamp and turn it on a turn quarter clockwise to fix a lamp on a place.

6. Establish a lamp cartridge in the back combined lantern and turn it on a turn quarter clockwise for cartridge blocking on a place.

7. Cautiously establish lantern knot on the car.

REPLACEMENT OF THE LAMP OF THE CEILING PLAFOND

PERFORMANCE ORDER

1. Using a flat screw-driver, cautiously remove glasses from the case of a ceiling plafond.

2. Press a lamp inside, then turn it on one quarter of a turn counter-clockwise and take out a lamp from a cartridge.

3. Insert a new lamp into a cartridge, further slightly press a lamp inside and turn it on a turn quarter clockwise so that the lamp was established into place.

4. Put two glasses to the case of a ceiling plafond according to cuts and latch glasses on the places.

REPLACEMENT OF THE LAMP OF THE LANTERN OF ILLUMINATION OF LICENSE PLATE

PERFORMANCE ORDER

1. Using a screw-driver for bolts Phillips, turn on two bolts, employees for glass fastening, and remove glasses.

2. Cautiously take out a lamp from a cartridge.

3. Insert a new lamp into a cartridge.

4. Establish back glasses and fix their two bolts.