Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
- 4. Cooling system
4.1. Specifications
4.2. A cooling liquid
4.3. Replacement of a cooling liquid
4.4. The water pump
4.5. A radiator
4.6. Check of tightness of system of cooling
4.7. The engine of the fan of a radiator
4.8. Check of a cover of a radiator
4.9. The valve of return pressure
4.10. The thermostat
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment
|
Sequence of removal of the water pump, the thermostat and pipes of system of cooling
1 – an entrance pipe of system of cooling and a lining;
2 – a bypass pipe and a sealing ring of round section;
3 – the water pump; |
4 – a lining of the water pump;
5 – the thermostat |
Removal
PERFORMANCE ORDER |
The prevention The water pump is not maintainable and in case of an exit it out of operation replace it in gathering.
|
1. Disconnect a wire from the negative plug of the storage battery. |
2. Remove a belt of a drive of hinged units. |
3. Remove a gear belt. |
4. Remove the pump of the amplifier of a steering to remove an entrance pipe of system of cooling. |
5. Remove all details in the sequence shown in drawing. |
|
Installation
PERFORMANCE ORDER |
1. Check up the water pump on absence of cracks and damages. |
2. Turn a shaft of the water pump and check up smoothness of rotation in the absence of noise. |
3. If necessary replace the water pump. |
|
Installation
PERFORMANCE ORDER |
1. Clear of the rests of a lining and an alien material a surface of consolidation of the water pump. |
2. Establish on the water pump a new lining.
Exclude lining falling as the layer of hermetic put on a lining, can be damaged. Establish a lining the party with hermetic to a condensed surface. |
3. The further installation is spent to sequences, return to removal. |
4. Fill in in cooling system necessary quantity of a demanded cooling liquid. |
5. Connect a wire to the negative plug of the storage battery. |
6. Start up the engine and check up absence of leaks from cooling system. |
|
|
|