KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
- 6. Ignition system
   6.1. Specifications
   6.2. Work of system of ignition
   6.3. Components of system of ignition
   6.4. A corner of an advancing of ignition
   6.5. The ignition coil
   6.6. Spark plugs
   6.7. High-voltage wires
+ 7. Coupling
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







6.4. A corner of an advancing of ignition
THE GENERAL DATA

Change of installation of a corner of an advancing of ignition can be caused two reasons: a problem with the gauge which will be found out by the block of engine management or wrong installation of a camshaft in relation to a cranked shaft. Last problem is connected with wrong installation of a gear belt of a drive газораспределительного the mechanism.

No adjustment after replacement of the coil of ignition is required.

Check

PERFORMANCE ORDER
1. Start up the engine and warm up it to working temperature.
2. Switch off all consumers of electric energy.
3. Connect to the engine a tachometre and to a high-voltage wire of the first cylinder the stroboscope gauge.
4. On combination of labels on a pulley of a cranked shaft with the index check up a corner of an advancing of ignition.

Corner of an advancing of ignition: 85 to ВМТ (6 5 for Europe) (on frequency of rotation of idling)


The prevention

The corner of an advancing of ignition is not regulated.