KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. A coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. A casing of coupling and press a disk
   7.8. Replacement of the central bearing
   7.9. A coupling pedal
   7.10. A coupling cable
   7.11. The bearing of deenergizing of coupling
   7.12. A plug of deenergizing of coupling \squeezing the lever
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







7.6. Check of a disk of coupling
PERFORMANCE ORDER
1. Check up a condition of frictional overlays of a disk of coupling and at presence with them of traces of oil or mechanical damages replace a coupling disk.

The prevention

Insignificant pollution remove a fine-grained emery paper.


2. Check up reliability заклепочных connections of frictional overlays to a coupling disk. In the presence of defects replace a coupling disk.
3. Check up выступание frictional overlays over heads of rivets. If выступание less admissible, replace a coupling disk.

Выступание: 0,3 mm

4. Establish a coupling disk on оправке in the centres and by the indicator of hour type measure its palpation. If palpation above admissible, replace a coupling disk.

Axial palpation: 0,7 mm
Radial palpation: 1,0 mm

5. Check up a coupling disk on absence of a rust in шлицах. In the presence of a rust, remove it.

Installation

PERFORMANCE ORDER
1. Establish a disk of coupling and centre its special оправкой ОК130 160 010.

The prevention

Combine labels on a flywheel and a casing the couplings put before removal.


2. Establish a casing of coupling with a press disk on directing pins of a flywheel.

3. Gradually in diagonal sequence and in a certain order tighten bolts of fastening of a flywheel.

The inhaling moment: 18–26 Nm

4. Remove special the mandrel ОК130 160 010.

The prevention

Before transmission installation clear шлицы in a nave of a disk of coupling and put on them a thin layer of greasing on a basis дисульфида molybdenum.


5. Establish a transmission.