Since 2000 of release

Repair and car operation

Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
- 7. Coupling
   7.1. Specifications
   7.2. Adjustment of a pedal of coupling
   7.3. Height of installation of a pedal of coupling
   7.4. A coupling disk
   7.5. Check of a casing of coupling with a press disk
   7.6. Check of a disk of coupling
   7.7. A casing of coupling and press a disk
   7.8. Replacement of the central bearing
   7.9. A coupling pedal
   7.10. A coupling cable
   7.11. The bearing of deenergizing of coupling
   7.12. A plug of deenergizing of coupling \squeezing the lever
+ 8. A transmission
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment

Где купить Семена цветов читать дальше.
Клининг офисов еще здесь.
÷веты в ростове на сайте

7.9. A coupling pedal

Coupling pedal

1 – шарнирный a bolt;
2 – a returnable spring;
3 – a nut;
4 – plugs;
5 – a clip;
6 – a coupling pedal;
7 – a brake pedal;
8 – a coupling cable.


1. Turn away adjusting nuts on the squeezing lever so that it was possible to remove a cable from the squeezing lever.
2. Remove a clip, крепящий a cable cover to an arm of a pedal of coupling.
3. Pull a cable upwards and disconnect it from a hook of a pedal of coupling.
4. Turn away a nut and remove spring and flat washers with шарнирного a bolt.
5. Remove a pedal of coupling with шарнирного a bolt and returnable springs.
6. If necessary remove a rubber overlay from a pedal of coupling and an emphasis.

The prevention

Apply a thin film литиевой greasings (NGLI Number 2) on plugs and points of turn of a pedal.


Installation is spent to sequences, return to removal.