Since 2000 of release

Repair and car operation

Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. A transmission
   - 8.1. A mechanical transmission
      8.1.1. Specifications
      8.1.2. Check of level of oil
      8.1.3. Oil replacement
      8.1.4. Replacement of an oil sealing ring
      8.1.5. Removal and transmission installation
      8.1.6. Dismantling, check and transmission assemblage
      8.1.7. Carter couplings and components картера transmissions
      8.1.8. A primary shaft of a transmission
      8.1.9. A secondary shaft of a transmission
      8.1.10. A choice of adjusting linings
      8.1.11. Differential
      8.1.12. The gear change mechanism
   + 8.2. Automatic transmission F4E–K
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment

Тфк для двойни смотрите на
landing page лендинг пейдж - заказать создание.
Ocs service еще по теме.
Протезирование китай подробнее.
ремонт акпп ауди ⧦

8.1.4. Replacement of an oil sealing ring
1. Lift the car and fix on support.
2. Turn out a stopper the oil plum, located in an end face of a transmission and merge oil in the suitable container.
3. Remove a forward wheel
4. Remove a mudguard.
5. Disconnect draught from the bottom lever of a forward suspension bracket.

The prevention

Do not damage dustproof covers.

6. Turn out a coupling bolt, mount wring out the bottom lever downwards and separate a pin of the hinge from a rotary fist.
7. Turn out a nut and stripper OK670 321 019 squeeze out a pin of the hinge of a tip of steering draught from a rotary fist.

The prevention

Do not damage the hinge of equal angular speeds (SHRUS) at branch of a power shaft from a transmission.

8. Insert mount between an internal SHRUS of a power shaft and a transmission and easy blow on mount take a power shaft from a transmission.

The prevention

At extraction of a power shaft from a transmission at once do not apply the big efforts, and made efforts increase gradually.

9. For an exception of damage of an external SHRUS of a power shaft a steel wire tie up a power shaft.

10. An edge of a flat screw-driver remove a sealing ring from a transmission nest.

The prevention

Clear a nest of a sealing ring and put on it a thin butter layer. Oil a working edge of a new sealing ring.

11. Using the mandrel OK201 170 AA1 establish a new sealing ring in a nest картера transmissions.
12. Replace a lock ring on the internal end of a power shaft and insert a power shaft into a transmission, thus a cut of a lock ring should settle down from above.