KIA RIO

Since 2000 of release

Repair and car operation



Kia Rio
+ 1.1. Short acquaintance to the car
+ 2. Engines A3E, А5D
+ 3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. A transmission
   + 8.1. A mechanical transmission
   - 8.2. Automatic transmission F4E–K
      8.2.1. Specifications
      8.2.2. Check of work and adjustment of position of the lever of the selector
      8.2.3. Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
      8.2.4. Time lag testing (Lag test)
      8.2.5. Pressure check трансмиссионной liquids
      8.2.6. Check of level and liquid replacement in an automatic transmission
      8.2.7. Procedure of replacement of a liquid in the converter of an automatic transmission
      8.2.8. Leaks of a liquid from an automatic transmission
      8.2.9. Replacement of oil sealing rings
      8.2.10. Removal and installation of an automatic transmission
      8.2.11. Repair of an automatic transmission
      8.2.12. A radiator of cooling of a liquid of an automatic transmission
      8.2.13. The block of valves
      8.2.14. The case of regulating valves
      8.2.15. The oil pump
      8.2.16. Check of resistance of the gauge of frequency of rotation of an entrance shaft \of a turbine wheel
      8.2.17. Check of resistance of the gauge of speed
      8.2.18. The switch of operating modes of transmission O\D
      8.2.19. The switch of a range of a transmission
      8.2.20. The gauge of temperature of an automatic transmission
      8.2.21. Electromagnetic valves
      8.2.22. The linear electromagnetic valve
      8.2.23. The selector lever
      8.2.24. Repair of the lever of the selector
      8.2.25. Check of functioning of the mechanism of blocking of the lever of the selector
+ 9. Axes and power shafts
+ 10. A suspension bracket
+ 11. Wheels and tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. Air central air
+ 16. The electric equipment







8.2.16. Check of resistance of the gauge of frequency, rotation of an entrance shaft / of a turbine wheel
PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Lift upwards a diagnostic socket from the gauge of a measuring instrument of the expense of air.
3. Remove the case of the air filter.
4. Disconnect a socket of the gauge of frequency of rotation of an entrance shaft / of a turbine wheel.
5. Measure resistance between contacts 1 and 2 sockets.

Resistance: 300~400 Ohm at 20 C

6. If resistance does not correspond to demanded values, replace the gauge.

The inhaling moment: 8–11 Nm

7. Establish the case of the air filter.
8. Establish a diagnostic socket.
9. Connect a wire to the negative plug of the storage battery.